Adjusting for DST on a JobClock/EX and LE

Last Modified on

Adjusting_For_DST_On_A_Hornet__360019355074__DST_change_2.png

Your JobClock/EX and LE will attempt to update its time automatically on the morning of the Daylight Saving Time change based on your time zone settings in ExakTime Connect.

If you are unsure of your Time Zone settings, you can refer to the following article: Time Zone & Daylight Saving Settings

Please note: If employees are working during the DST time change, this will require manual adjustment on the employees respective time card.

Adjusting for DST on a JobClock/EX

Whenever you are collecting from your JobClock/EX with a FastTrakker Pro or JobClock Reader on a supported device, the JobClock/EX will receive DST settings from the time zone settings of your Connect system so that it will automatically adjust at the appropriate time.

If you want to be sure that the time of the JobClock/EX is correct, you can collect from the JobClock/EX between the time frame after the DST adjustment and before the first employee clocking in to set the date/time to match the time of the collection device.

Adjusting for DST on a JobClock/LE

Whenever you are collecting from your JobClock/LE with JobClock Reader on a supported device, the JobClock/LE will receive DST settings from the time zone settings of your Connect system so that it will automatically adjust at the appropriate time.

If you want to be sure that the time of the JobClock/LE is correct, you can collect from the JobClock/LE between the time frame after the DST adjustment and before the first employee clocking in to set the date/time to match the time of the collection device.

 

Comments 0